Multicam Audio - no dual mono?

Hey!

I'm having problem to get the audio in an multicam clip to appear as dual mono. Even if I go into the angle editor and change to dual mono I cannot make that happen in the timeline... Any ideas?

Did you set the channel configuration in the inspector for dual mono once back in the timeline? You might also have to reset the default configuration depending on how your import settings for the audio were configured.

Now I can set it to dual mono but then it looks like it sets the whole project to mono and I can't here the sound, unless I activate a different angle that is in stereo then I get sound. Wtf? Need to delve into this some more...

Changing a channel configuration for a clip in the timeline won't change your project from stereo to mono. Click on the project and confirm it is stereo, if not, click modify settings and change it to stereo.

Click on the clip in the Timeline, "Expand Audio Components", and you should see all audio channels that have been activated in the Inspector, and in that specific configuration. You can activate all channels for all angles, too. That don'ts work?

dgwvideo wrote: Changing a channel configuration for a clip in the timeline won't change your project from stereo to mono. Click on the project and confirm it is stereo, if not, click modify settings and change it to stereo.

I did that. But for some reason it was in mono and I couldn't hear any audio in my speakers. It was very weird. I trashed everything now as I have to start over anyway... We'll see!